Finding the Right Appliance Service Company

« Back to Home

3 Signs Your Washer Needs Repairs

Posted on

Over time, appliances can break down, which can leave you without much needed services inside your home. One such appliance that causes a major inconvenience when it stops working is your washing machine. Yet, with a little know-how you can detect mounting problems before your washer stops altogether. So, if you notice any of the following, you should call for service call before it breaks down.

There is Water Everywhere

Without water, a washing machine simply can't work. Yet, if you notice small puddles forming every time you turn the machine on, it is very likely that something is amiss. This is usually caused by water not draining properly from the unit or a faulty seal on the unit. Other symptoms of trouble here are trying to get your clothes out, only to find them soaking wet still and dripping water all over the place. In this event, there could be a blockage in one of the drainage holes that desperately needs to be cleaned out. Getting the jump on this repair can save you a lot of frustration, for if it is left alone long enough you could find your laundry room flooding.

Your Washer is Making Excessive Amounts of Noise

Your washing machine, while a tad noisy, should never be at a point where it is shaking violently during the most minor of loads. First, it is a good idea to make sure your washing machine is on a level surface, as sitting on uneven ground can throw it off balance and make for an unpleasantly loud experience. However, if your best efforts don't rectify the problem, then it is very likely that either the drum itself or the motor might be loose. This can be tricky to get to on your own, so a service call is your best bet. 

Your Washer Fills with Water, but the Drum Doesn't Spin

This one can be frustrating, since your washer is almost working, but without any spinning it doesn't successfully wash the clothes. In this event, there most likely has been a belt failure somewhere. Other cases can be a faulty lid, which never indicates that the washer is closed and therefore never allows it to start spinning due to safety reasons. Both of these are relatively simple fixes for any service technician, who will be more than happy to get your washer back in working order.

Just remember, your washer is an appliance like anything else, which means eventually you'll see problems somewhere down the line. So, before the washer breaks down entirely, you really should consider looking into repairs. To learn more, contact a company like Ray's Appliances.


Share